A Speed dial on knob 1 (CC 30) sets the step time of the cans' and movers'
chase and zigzag runs, from 800 ms fully left to 50 ms fully right, starting
at the old 200 ms. Zigzag forward stays at half the step, and the dimmer holds
follow at 8 steps so they stretch with the run. The 500 ms trail is unchanged.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
The front right mover is on DMX 1 and the front left on 45, so M1 and M2
swap addresses in the stage map and test.qxw. Measured on the rig, pan 0
faces forward on the front pair and into the middle on the back pair, back
at 85. M1 and M4 turn anticlockwise, so movers get a pan_reverse flag.
Tilt 127 now points straight down: the simulator draws a spot under the
head, and past 127 the beam flips behind the pan heading.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
The Dimmers sliders are now Middle, Front and Back, and the movers' Brightness
(knob 15) leads the Movers position frame.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Pause toggles bank 1 between the cans and the movers (scripts/shows/mover_bank.py).
Knobs 9-12 (CC 38-41) drive all four movers' pan, tilt, focus and lens
rotate, as in templeoftechno.qxw (scripts/shows/mover_position.py).
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
The Sound pad (bank 1 note 36) toggles a QLC+ Audio Triggers widget whose
volume bar drives a Sound submaster beside the can dimmers, so the cans'
brightness follows the music while the movers stay steady. padcontroller sends
CC 100 at full on every press and release of that pad, bypassing its CC
smoothing, so switching sound off always leaves the cans at full.
test.qxw also gains Chase forward/reverse, a double and an opposing zigzag
down the side cans (RGB matrices whose colour follows the Colour 2 pads), a
Strobe flash pad with the cans' strobe channel forced HTP, and the Dimmers
frame, forced-LTP side colours and dimmer-free colour scenes from parallel
sessions.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>