| MEMTYPE_FLASH_PAGE | - | RW | Used for writing FLASH before a debug session, and reading FLASH during a debug session. Only FULL PAGE access is allowed. If the number of bytes requested does not match the flash page size, an error is returned (AVR8_FAILURE_INVALID_SIZE). Software breakpoints are NOT filtered out.
|
| MEMTYPE_SIGNATURE | - | R | Used to read the device signature stored in the debugWIRE module itself. This signature may differ from the signature stored in FLASH and accessed through SPI programming interface. A read MUST be for exactly 3 bytes from address 0x00. Violating this will results in an error (AVR8_FAILURE_INVALID_SIZE / AVR8_FAILURE_INVALID_ADDRESS). Byte 2 will always read 0x1E.
|
| MEMTYPE_SRAM | - | RW | Accesses SRAM and IO space during debugging. If used in programming mode, an error is returned (AVR8_FAILURE_ILLEGAL_STATE) If a read attempts to read an area containing the OCDR register, an error is returned (AVR8_FAILURE_INVALID_ADDRESS). A masked read must be used in this case. Any number of bytes (within payload restrictions) can be written or read in one operation.
|
| MEMTYPE_EEPROM | - | RW | Used to read and write EEPROM during a debug session. Any number of bytes can be written or read in one operation. Uses monitor code heavily - may take some time to complete, depending proportionally upon the number of bytes being accessed.
|
| MEMTYPE_SPM | - | R | Used to access small amounts of FLASH during a debug session. If an odd number of bytes is requested, an error is returned
. This memtype is efficient for reading full pages, or single words from FLASH. Multiple word requests are inefficient and may take time to complete. Software breakpoints are filtered out.
|
