Add a FAQ entry describing the method to connect to a device
where the firmware has reduced the internal clock speed.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1218 81a1dc3b-b13d-400b-aceb-764788c761c2
* avrdude.conf: Bump the chip_erase_delay for all ATmega*4 devices
to 55 ms. While the datasheet still claims 9 ms, all the XML files
tell either 45 or 55 ms, depending on STK600 or not.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1217 81a1dc3b-b13d-400b-aceb-764788c761c2
* jtagmkII_private.h (MTYPE_EEPROM_XMEGA): New memory type.
* jtagmkII.c (jtagmkII_write_byte): For Xmega EEPROM, use
memory type MTYPE_EEPROM_XMEGA; for flash writes, always
write 2 bytes starting on an even address.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1212 81a1dc3b-b13d-400b-aceb-764788c761c2
algorithm for EEPROM when being connected through debugWIRE.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1210 81a1dc3b-b13d-400b-aceb-764788c761c2
EEPROM. (Flash cells must have been erased before though.)
* jtag3.c (jtag3_initialize): OCDEN no longer needs to be
considered; a session with "programming" purpose is sufficient
* jtag3.c (jtag3_write_byte): Use the paged algorithm for all
flash and EEPROM areas, not just Xmega.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1209 81a1dc3b-b13d-400b-aceb-764788c761c2
* jtag3_private.h (MTYPE_EEPROM_XMEGA): New define.
* jtag3.c (jtag3_write_byte): When updating flash or
EEPROM on Xmega devices, resort to jtag3_paged_write()
after filling and modifying the page cache.
* jtag3.c (jtag3_paged_write): use MTYPE_EEPROM_XMEGA
where appropriate.
* jtag3.c (jtag3_initialize): Open with debugging intent
for Xmega devices, so single-byte EEPROM updates will
work.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1208 81a1dc3b-b13d-400b-aceb-764788c761c2
bug #38951: AVR109 use byte offset instead of word offset
patch #8045: AVR109 butterfly failing
* butterfly.c (butterfly_paged_load, butterfly_paged_write):
fix calculation of 'A' address when operating on flash memory.
It must be given in terms of 16-bit words rather than bytes.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1205 81a1dc3b-b13d-400b-aceb-764788c761c2
* jtag3.c (jtag3_initialize): initialize the eeprom_pagesize
private attribute so the page cache will actually be usable
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1202 81a1dc3b-b13d-400b-aceb-764788c761c2
* jtag3.c (jtag3_read_byte, jtag3_write_byte): Correctly apply the
relevant part of mem->offset as the address to operate on.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1201 81a1dc3b-b13d-400b-aceb-764788c761c2
bug #35800: Compilation error on certain systems if parport is disabled
* linux_ppdev.h: Conditionalize inclusion of <linux/parport.h> and
<linux/ppdev.h> on HAVE_PARPORT
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1198 81a1dc3b-b13d-400b-aceb-764788c761c2
* pickit.c (usb_open_device): Use %p rather than %X to print "handle"
which is a pointer
* jtag3.c (jtag3_initialize): Initialize "flashsize" to be sure it
proceeds with a valid value.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1197 81a1dc3b-b13d-400b-aceb-764788c761c2
* buspirate.c: Turn the "cmd" argument of the various methods into
a "const unsigned char *"; while doing this, declare all arrays being
passed as arguments to be pointers rather than arrays, as the latter
obfuscates the way arrays are being passed to a callee in C.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1196 81a1dc3b-b13d-400b-aceb-764788c761c2
to upload an invalid Intel HEX file
* fileio.c (ihex2b): Turn the "No end of file record found" warning
into an error if no valid record was found at all.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1195 81a1dc3b-b13d-400b-aceb-764788c761c2
bug #38713: Compilation of the documentation breaks with texinfo-5
* doc/avrdude.texi: Turn @itemx into @item, add @headitem to STK600
Routing/Socket card table
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1194 81a1dc3b-b13d-400b-aceb-764788c761c2
buffer address.
* usbasp.c (usbasp_tpi_paged_write): Calculate correct
buffer address; don't issue a SECTION_ERASE command for
each page (a CHIP_ERASE has been done before anyway);
remove the code that attempted to handle partial page
writes, as all writes are now done with a full page.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1191 81a1dc3b-b13d-400b-aceb-764788c761c2
* stk500v2.c (stk600_xprog_page_erase): Fix argument that is
passed to stk600_xprog_memtype()
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1188 81a1dc3b-b13d-400b-aceb-764788c761c2
elf_getshdrstrndx() as the former one is deprecated
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1187 81a1dc3b-b13d-400b-aceb-764788c761c2
* avrftdi.c, avrftdi_private.h: added additional pin check and bitbanging fallback
* pindefs.[ch]: added a flag to enable/disable output
* ft245r.c: changes because of added flag above
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1184 81a1dc3b-b13d-400b-aceb-764788c761c2
patch #7876 JTAGICE mkII fails to connect to attiny if debugwire
is enabled AND target has a very slow clock
* jtagmkII.c (jtagmkII_getsync): When leaving debugWIRE mode
temporarily, immediately retry with ISP, rather than leaving.
* stk500v2 (stk500v2_program_enable): Implemented similar logic
for the JTAGICE3.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1183 81a1dc3b-b13d-400b-aceb-764788c761c2
* avrftdi*.*: changed include check for libftdi/libusb, deactivate 232H if not available
* ft245r.c: changed include check for libftdi/libusb
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1180 81a1dc3b-b13d-400b-aceb-764788c761c2
* avrdude.conf.in: fixed buff pins of avrftdi programmers (low active buffer need now inverted numbers)
* avrftdi*.*: accept also old libftdi (0.20 still works with it), added powerup to initialize
* ft245r.c: accept libftdi1, code cleanup and make it more similar to avrfdti (os they might be merged someday)
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1175 81a1dc3b-b13d-400b-aceb-764788c761c2
avrftdi.c: add pgm->power[up|down] functions and fill
pgm->enable|disable with proper functionality, as suggested by
rliebscher.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1171 81a1dc3b-b13d-400b-aceb-764788c761c2
Use pin_checklist[] of size N_PINS instead N_PINS - 1, to avoid future
problems. Also remove pins_check from set_pin; instead use mask[0] == 0
to check wether to do something or not.
avrftdi_private.h: Change size of pin_checklist[] to N_PINS.
avrftdi.c: Adapt code to new size of pin_checklist. Remove pins_check
from set_pin.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1170 81a1dc3b-b13d-400b-aceb-764788c761c2
otherwise use unsinged long
* ft245r.c: added support for more pin functions led, vcc, buff
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1169 81a1dc3b-b13d-400b-aceb-764788c761c2
Generic function enabling external programming on TPI devices. This
function sets the required guard time (which is passed in as parameter),
checks the TPI identification register, writes SKEY command + SKEY, and
finally polls the NVMEN bit in TPISR.
avr.h: Add prototype definitions of avr_tpi_program_enable() and
avr_tpi_chip_erase().
avrftdi_tpi.c: Removes tpi_skey_cmd array, containing the SKEY command
and the SKEY bytes.
tpi.h: Adds tpi_skey_cmd array, containing the SKEY command and the SKEY
bytes, but in the reverse order of tpi_skey.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1167 81a1dc3b-b13d-400b-aceb-764788c761c2
avrdude.conf.in: Change all programmers' pin definitions to 0-based
avrftdi.c: incorporate new 0-based pindef infrastructure
avrftdi_private.h: Add pin_checklist_t to avrftdi_t for runtime pin
checking in pgm->setpin.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1164 81a1dc3b-b13d-400b-aceb-764788c761c2
* avrpart.[ch]: moved avr_pin_name to pindefs.[ch]
* pgm.c: moved pins_to_str to pindefs.[ch], added initialization of
new pin definitions in pgm_new()
* pindefs.[ch]: added moved functions from other files, added a lot of
documentation, reformatted files using astyle to have consistent spacing,
added a new generic check function for pins
* ft245r.c: used new generic pin check function
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1161 81a1dc3b-b13d-400b-aceb-764788c761c2
* avrftdi.c,buspirate.c,linuxgpio.c,par.c,serbb_*.c: added function call
to fill old pinno entries from new pin definitions.
* pindefs.[hc]: added data struct and helper functions for new pin definitions
* avrdude.conf.in: pins in entries using ftdi_syncbb are now 0-based
* config_gram.y: allow combinations of inverted and non-inverted pins in pin lists
* ft245r.c: reworked to work directly with the new pin definitions,
pins are now 0-based, inverse pins are supported, buff is supported
* pgm.[ch]: added new pin definitions field to programmer structure,
adapted pin display functions
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1160 81a1dc3b-b13d-400b-aceb-764788c761c2
joerg_wunsch
rliebscher
hweisbach