menu "Bridge Ethernet (W5500)" config BRIDGE_ETH bool "W5500 Ethernet with a UDP bridge" default y if IDF_TARGET_ESP32S3 default n help The board has a W5500 on SPI, wired to the network. It takes UDP datagrams on BRIDGE_ETH_PORT (dst_mac + packet, sent on ESP-NOW) and sends frames it hears back to the last sender (src_mac + packet). Its address is logged over the USB link once DHCP answers. config BRIDGE_ETH_PORT int "UDP port" depends on BRIDGE_ETH default 8766 config BRIDGE_ETH_AUDIO_PORT int "UDP control port (microphone audio and HELLO)" depends on BRIDGE_ETH default 8767 config BRIDGE_ETH_SPI_CLOCK_MHZ int "SPI clock (MHz)" depends on BRIDGE_ETH range 5 80 default 20 config BRIDGE_ETH_SCLK_GPIO int "SCLK GPIO (XIAO D8)" depends on BRIDGE_ETH default 7 config BRIDGE_ETH_MISO_GPIO int "MISO GPIO (XIAO D9)" depends on BRIDGE_ETH default 8 config BRIDGE_ETH_MOSI_GPIO int "MOSI GPIO (XIAO D10)" depends on BRIDGE_ETH default 9 config BRIDGE_ETH_CS_GPIO int "CS GPIO (XIAO D1)" depends on BRIDGE_ETH default 2 config BRIDGE_ETH_INT_GPIO int "INT GPIO (XIAO D2), -1 to poll" depends on BRIDGE_ETH default 3 config BRIDGE_ETH_RST_GPIO int "RST GPIO (XIAO D0), -1 if not wired" depends on BRIDGE_ETH default 1 endmenu menu "Bridge microphone (I2S)" config BRIDGE_MIC bool "Stream an I2S microphone to the host" default y if IDF_TARGET_ESP32S3 default n help The host (led-controller on the desktop) can record from an I2S mic on this board (INMP441 wiring, as on the controller's XIAO ESP32-S3). Off on boards without one. config BRIDGE_MIC_SCK_GPIO int "I2S SCK (bit clock) GPIO" depends on BRIDGE_MIC default 5 config BRIDGE_MIC_WS_GPIO int "I2S WS (word select) GPIO" depends on BRIDGE_MIC default 6 config BRIDGE_MIC_SD_GPIO int "I2S SD (data) GPIO" depends on BRIDGE_MIC default 43 endmenu