# esp32vga 800×600 VGA output with a web interface for the Seeed XIAO ESP32S3 Plus (16 MB flash, 8 MB PSRAM). It uses 8-bit colour (RGB332) from the LCD_CAM peripheral, with double buffering in PSRAM. Content modes include a test pattern, plasma, starfield, clock, Mandelbrot, text messages, images (uploaded and dithered in the browser, with a 15-slot gallery in flash), a Halloween scene and "Haunting", a black-background mode for projecting onto fabric. ## Wiring | XIAO pin | GPIO | Signal | Resistor | VGA pin | |---|---|---|---|---| | D0 | 1 | Blue bit 0 | 820 Ω | 3 | | D1 | 2 | Blue bit 1 | 430 Ω | 3 | | D2 | 3 | Green bit 0 | 2 kΩ | 2 | | D3 | 4 | Green bit 1 | 1 kΩ | 2 | | D4 | 5 | Green bit 2 | 510 Ω | 2 | | D5 | 6 | Red bit 0 | 2 kΩ | 1 | | D6 | 43 | Red bit 1 | 1 kΩ | 1 | | D7 | 44 | Red bit 2 | 510 Ω | 1 | | D8 | 7 | HSYNC | 100 Ω | 13 | | D9 | 8 | VSYNC | 100 Ω | 14 | Ground goes to VGA pin 5 and pins 6–8, and VGA pin 9 (+5 V) is left unconnected. ## Build and flash You need ESP-IDF 5.4 or later. The paths at the top of the `Makefile` point at the toolchain to use; override them if yours are elsewhere. ``` make # build make flash # flash over USB (PORT=/dev/ttyACM0) make ota # flash over WiFi (BOARD=) make monitor # serial console make font # regenerate main/font_data.h make clean ``` The serial console is on the USB-Serial-JTAG port, because GPIO 43/44 carry colour bits. ## Web interface The board starts its own access point, `ESP32-VGA` (password `esp32vga`). You can also give it your home WiFi details in Settings. Open its IP address in a browser. To update the firmware over WiFi, use the page's Settings section or `make ota`.