* avrdude.conf.in (m324a): New entry.
Submitted by Björn Mellström
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1449 81a1dc3b-b13d-400b-aceb-764788c761c2
* avrdude.conf.in (m328pb): Add own efuse definition
Submitted by Ronald Sutherland
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1448 81a1dc3b-b13d-400b-aceb-764788c761c2
* avrdude.conf (jtag3updi): New entry.
Submitted by Sven Schwermer:
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1445 81a1dc3b-b13d-400b-aceb-764788c761c2
* usbtiny.c (usbtiny_paged_load, usbtiny_paged_write): ensure chunk
does not overflow memory area
Submitted by Joel Ray Holveck
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1444 81a1dc3b-b13d-400b-aceb-764788c761c2
Submitted by Adrian Klieber
patch #9818: correct typos in SVN rev 1429
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1443 81a1dc3b-b13d-400b-aceb-764788c761c2
patch #9893: [PATCH] Reader reads ftdi handle after main thread close it
* ft245r.c: Wait until reader thread has been stopped before closing FTDI
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1434 81a1dc3b-b13d-400b-aceb-764788c761c2
patch #8311: Add IPv6 support to the -Pnet:host:port option
* ser_posix.c (net_open): Rewrite to use getaddrinfo()
rather than gethostbyname()
* avrdude.1: Document IPv6 feature
* doc/avrdude.texi: (Dito)
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1421 81a1dc3b-b13d-400b-aceb-764788c761c2
patch #8219: Fix boot_start for xmega devices on jtagmkII
* jtagmkII.c (jtagmkII_initialize): Determine boarder between
application and boot area correctly.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1418 81a1dc3b-b13d-400b-aceb-764788c761c2
patch #8580: FT245r support to select device by serial number
* ft245r.c (ft245r_open): Add serial number parsing.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1415 81a1dc3b-b13d-400b-aceb-764788c761c2
patch #9222: Enable silent build
* configure.ac: Add AM_SILENT_RULES
* Makefile.am: Document how to run "make" to get verbose
build messages
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1411 81a1dc3b-b13d-400b-aceb-764788c761c2
patch #9317: Support atmega64m1 as part
* avrdue.conf.in (ATmega64M1): New entry.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1410 81a1dc3b-b13d-400b-aceb-764788c761c2
patch #9423: Support ATtiny841 and ATtiny441
bug #47376: ATtiny841 description missing in configuration file
bug #49455: support for tiny441
* avrdude.conf.in (ATtiny841, ATtiny441): New entries
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1408 81a1dc3b-b13d-400b-aceb-764788c761c2
Thanks to Morten Engelhardt Olsen for his contribution!
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1406 81a1dc3b-b13d-400b-aceb-764788c761c2
* usb_libusb.c: Add endpoint IDs for Xplained Mini, correctly
transfer trailing ZLP when needed
* avrdude.conf.in (xplainedmini, xplainedmini_dw): New entries.
* jtag3.c (jtag3_edbg_send, jtag3_edbg_recv_frame): Implement
fragmentation needed for the 64-byte EP size of the Xplained Mini
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1369 81a1dc3b-b13d-400b-aceb-764788c761c2
bug #46483: version 6.2. ser_open(): can't set attributes for device
* ser_posix.c: Back out change from patch #8380
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1365 81a1dc3b-b13d-400b-aceb-764788c761c2
When about to write an empty flash dump file, warn about this to avoid
surprises.
Document the truncation of trailing 0xFF bytes for flash memory areas.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1355 81a1dc3b-b13d-400b-aceb-764788c761c2
* ser_posix.c: Add a hack to allow for arbitrary baud rates on
Linux
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1351 81a1dc3b-b13d-400b-aceb-764788c761c2
* configure.ac: Check for ws2_32 library
* ser_win32.c: Add hooks for forwarding serial data over
TCP connections
* avrdude.1: Drop previous restriction of -P net:
* doc/avrdude.conf: (Dito.)
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1350 81a1dc3b-b13d-400b-aceb-764788c761c2
* jtag3.c (jtag3_initialize): Retry with external reset applied if
the first sign-on attempt fails.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1349 81a1dc3b-b13d-400b-aceb-764788c761c2
order to specify a bitclock frequency rather than period.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1347 81a1dc3b-b13d-400b-aceb-764788c761c2
* jtag3.c (jtag3_edbg_recv_frame): Return correct length as
reported in the response packet, rather than full 512 byte which
are always reported by the CMSIS-DAP layer. Miscalculations
based on the wrongly reported length caused heap corruption
elsewhere, so this is presumably also a fix for bug #43078.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1344 81a1dc3b-b13d-400b-aceb-764788c761c2
flash page
* usbasp.c (usbasp_spi_paged_write): Remove USBASP_BLOCKFLAG_LAST.
It is no longer needed, as we always write full pages now in paged
write mode.
This prevents each flash page from being written twice, where the
second attempt on older devices (ATmega64/128) signalled an immediate
"ready" condition when polling (likely a silicon bug) even though they
were still in progress. This caused the USBasp firmware to proceed,
and fill the page buffer anew which eventually caused the data
corruption.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1343 81a1dc3b-b13d-400b-aceb-764788c761c2
after changing lock byte
* stk500v2.c (stk500isp_write_byte): As a workaround for broken
tool firmware, add 10 ms of delay before returning from any
single-byte write operation.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1337 81a1dc3b-b13d-400b-aceb-764788c761c2
every byte-wide access (rather than JTAGICE3 only). This finally
obsoletes the use of the prehistoric SPI_MULTI command where
AVRDUDE used to assemble all the low-level ISP stuff by itself.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1336 81a1dc3b-b13d-400b-aceb-764788c761c2
* avrdude.conf.in (m168, m328, m48, m88, t1634, t26, t261, t461,
t861, t88): In efuse (or hfuse for t26) read operation, turn all
bits in byte 3 from "x" to "o" (output); this is a first step
towards fixing the symptoms mentioned in the bug, by unifying the
behaviour between different AVRs. Not touched are the historic
devices where the fuses are not documented to form a full byte
each (2333, 4433, 4434, 8535, m103, m161, m163).
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1335 81a1dc3b-b13d-400b-aceb-764788c761c2
* usb_libusb.c (usbdev_close): Only issue the usb_reset() for
Linux systems, as these are the only ones that seem to require
it under some circumstances.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1273 81a1dc3b-b13d-400b-aceb-764788c761c2
patch #7896: DFU FLIPv2 programming support
* pgm_type.c: Add the flip2 programmer type.
* config_gram.y: Allow for the usbid keyword in a device definition.
* avrdude.conf.in: Add usbpid values to those Xmega devices where
applicable.
* avrpart.h: Add usbpid device field.
* dfu.c: (New file.)
* dfu.h: (New file.)
* flip.c: (New file.)
* flip.h: (New file.)
* Makefile.am: Add new files.
* doc/avrdude.texi: Document the changes.
* avrdude.1: (Dito.)
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1258 81a1dc3b-b13d-400b-aceb-764788c761c2
* fileio.c (fileio): open file in binary mode also for FMT_ELF
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1253 81a1dc3b-b13d-400b-aceb-764788c761c2
* main.c: Always clear the UF_AUTO_ERASE flag if either a
non-Xmega device was found, or the programmer does not offer a
page_erase method.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1242 81a1dc3b-b13d-400b-aceb-764788c761c2
bug #40040: Support for ATtiny20 and ATtiny40
* avrdude.conf.in: Restructure the reduced-core tiny devices
to use a common entry .reduced_core_tiny; add ATtiny20 and
ATtiny40
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1236 81a1dc3b-b13d-400b-aceb-764788c761c2
previous version) features on top so they will become immediately apparent
in the release notes.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1233 81a1dc3b-b13d-400b-aceb-764788c761c2
bug #40033: Support for the XMegaE5 family
* avrdude.conf.in (ATxmega8E6, ATxmega16E5, ATxmega32E5): New
entries.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1231 81a1dc3b-b13d-400b-aceb-764788c761c2
patch #7710: usb_libusb: Check VID/PID before opening device
* usb_libusb.c (usbdev_open): Swap the sequence of verifying the
VID:PID, and opening the device.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1228 81a1dc3b-b13d-400b-aceb-764788c761c2
patch #7657 Add ATmega406 support for avrdude using DRAGON + JTAG
* avrdude.conf.in (ATmega406): New entry.
git-svn-id: svn://svn.savannah.nongnu.org/avrdude/trunk/avrdude@1225 81a1dc3b-b13d-400b-aceb-764788c761c2
Joerg Wunsch
Rene Liebscher