In order to get meaningful const properties for the PROGRAMMER, AVRPART and
AVRMEM arguments, some code needed to be moved around, otherwise a network of
"tainted" assignments risked rendering nothing const:
- Change void (*enable)(PROGRAMMER *pgm) to void (*enable)(PROGRAMMER *pgm,
const AVRPART *p); this allows changes in the PROGRAMMER structure after
the part is known. For example, use TPI, UPDI, PDI functions in that
programmer appropriate to the part. This used to be done later in the
process, eg, in the initialize() function, which "taints" all other
programmer functions wrt const and sometimes requires other finessing with
flags etc. Much clearer with the modified enable() interface.
- Move TPI initpgm-type code from initialize() to enable() --- note that
initpgm() does not have the info at the time when it is called whether or
not TPI is required
- buspirate.c: move pgm->flag to PDATA(pgm)->flag (so legitimate
modification of the flag does not change PROGRAMMER structure)
- Move AVRPART_INIT_SMC and AVRPART_WRITE bits from the flags field in
AVRPART to jtagmkII.c's private data flags32 fiels as FLAGS32_INIT_SMC and
FLAGS32_WRITE bits
- Move the xbeeResetPin component to private data in stk500.c as this is
needed by xbee when it saddles on the stk500 code (previously, the flags
component of the part was re-dedicated to this)
- Change the way the "chained" private data are used in jtag3.c whilst
keeping the PROGRAMMER structure read-only otherwise
- In stk500v2.c move the STK600 pgm update from stk500v2_initialize() to
stk500v2_enable() so the former keeps the PROGRAMMER structure read-only
(for const assertion).
- In usbasp change the code from changing PROGRAMMER functions late to
dispatching to TPI or regular SPI protocol functions at runtime; reason
being the decision whether to use TPI protocol is done at run-time
depending on the capability of the attached programmer
Also fixes Issue #1071, the treatment of default eecr value.
For paged read/write early AVRDUDE implementations of the STK500 v1 protocol
communicated a word address (below a_div=2) or byte address (a_div=1) based
on the following code irrespective of which memories were used:
if(m->op[AVR_OP_LOADPAGE_LO] || m->op[AVR_OP_READ_LO])
a_div = 2;
else
a_div = 1;
This turned out to be a bug: it really should have been a_div=2 for flash and
a_div=1 for eeprom. At the time presumably no one noted because Atmel was at
the cusp of replacing their FW 1.x with FW 2 (and the STK500 v2 protocol).
It seems that the world (optiboot, Arduino as ISP, ...) has compensated for
the bug by assuming AVRDUDE sends *all* eeprom addresses as word addresses.
Actually these programmers overcompensated for the bug because for six out of
the 146 known SPI programmable parts with eeprom and page size > 1, AVRDUDE
would still send the eeprom addresses as byte addresses (ATmega8 ATmega8A
ATmega64 ATmega64A ATmega128 ATmega128A) owing to above code.
It makes no sense to correct the bug now seeing that virtually no one uses
the old 2005 STK 500 v1 firmware. This commit now follows optiboot, Arduino
as ISP and other projects, and simply sends all addresses for paged read or
write as word addresses. There are no longer (little known) exceptions for
ATmega8 et al that surprised some optiboot etc users.
Stefan Rueger
MCUdude
Marius Greuel
Dawid Buchwald